{"warranty":{"warranty":4,"url":"https:\/\/greenworks.antradar.com\/jsapi\/warranties\/warranty-4.png"}}

• 2404502CA - 80V 145 MPH - 580 CFM Brushless Axial Blower (Tool Only) - BL80L00
• 2901302CA - 80V 2.0Ah Lithium-ion Battery - GBA80200
• 2901402 - 80V Single Port Rapid Charger - GCH8040
• Owner's Manual

{"productcombos"=>Metafields::JsonStringDrop}

{"5"=>{"faqid"=>5, "faqtitle"=>"Do you make Gas Blowers?", "faqdesc"=>"All Greenworks leaf blowers are cordless, battery-powered blowers or corded. Greenworks does not make gas-powered models."}, "6"=>{"faqid"=>6, "faqtitle"=>"Is a battery powered leaf blower quieter than gas?", "faqdesc"=>"Electric and battery-powered leaf blowers – in general, are quieter than gas models. DB rating does depend on the model. Depending on the yard you intend to work on, the airflow coming from the device can be a primary factor as well."}, "7"=>{"faqid"=>7, "faqtitle"=>"What is more important MPH or CFM?", "faqdesc"=>"Both CFM and MPH have their benefits. It would depend on which type of blower you’re looking for.\n\nMPH is an abbreviation of miles per hour. This denotes the speed at which the air exits the blower. Higher MPH figures produce large pressure changes at the blower inlet. Therefore, a higher MPH is beneficial when looking at blower/vac units. MPH is usually the more important stat here as a higher airspeed helps move heavier debris.\n\nCFM is an abbreviation of cubic feet per minute. This denotes the volume of air displaced by the blower. High CFM units tend to move large air volumes at relatively low speeds allowing large areas to be swept and cleared in a controlled, shorter time. Therefore, axial blowers/dedicated blowers benefit more from a higher CFM and is more desirable for these units"}, "8"=>{"faqid"=>8, "faqtitle"=>"What is the most appropriate blower for my property?", "faqdesc"=>"Generally, electric leaf blowers have a CFM falling somewhere from just under 200 to 400. If your property is an acre or more, you will probably want a leaf blower with a CFM between 400 to 700"}, "10"=>{"faqid"=>10, "faqtitle"=>"Can I dry my car or blow snow off my driveway?", "faqdesc"=>"We do not recommend using this blower for any task other than leaf blowing."}, "15"=>{"faqid"=>15, "faqtitle"=>"What is the difference between a hand blower and backpack blower?", "faqdesc"=>"Hand-held blowers are often less expensive than backpack blowers. They have smaller motors to ensure they're not too heavy to carry. Since the motor is smaller, they have less power. These blowers are great if you have a small yard, but can be taxing if you’re spending 30-40 minutes on the job.\n\nBackpack blowers provide more power, and you can carry them wherever you go. They have the added benefit of being more ergonomic since you are not relying solely on arm strength. Backpack blowers are better for tackling large jobs, but they’re also more expensive than the hand-held blower"}, "16"=>{"faqid"=>16, "faqtitle"=>"How do I use the mulch function with my blower/vacuum?", "faqdesc"=>"When mulching leaves the Blower/Vac must be in TURBO-MULCH mode. Items such as small leaves and twigs will be mulched as they pass through the fan housing. We recommend emptying the bag after each use to avoid deterioration and obstructing air flow, which will reduce the performance of the mulcher."}, "17"=>{"faqid"=>17, "faqtitle"=>"Why is dust coming out of my collection bag while using my Blower?", "faqdesc"=>"There are tiny holes in the collection bag that are necessary for the operation of the Greenworks collection bag. These will allow very small particles of dust to pass through."}, "21"=>{"faqid"=>21, "faqtitle"=>"Why is my vacuum not collecting garden debris?", "faqdesc"=>"If your blower is not easily picking up the leaves, ensure that the nozzle is close enough to the leaves. Also make sure that the mode indicator is on the correct setting. \nPress the low/high switch to increase the speed options.\nThe unique design of the blower-vac means that only light weight, low density objects such as leaves, and garden debris will be collected. It’s worth noting, higher density objects such as stones and sticks will not be collected.\nIf you are finding the unit is still not picking up it may be necessary to remove the blower tube or mulcher tubes to clear a blocked tube or impeller. Please be sure to remove the battery or unplug the unit before checking the tube or impeller."}, "22"=>{"faqid"=>22, "faqtitle"=>"What blower can I use for Hard surfaces?", "faqdesc"=>"The best push power for removing heavy or wet organic materials from soft surfaces like grass, dirt or sand will come from a corded electric blower or from our 80V PRO blowers. The 80V 580 CFM Brushless Backpack Blower, with up to 580 CFM at 145 or the 80V 500 CFM Cordless Brushless Axial Blower with up to 500 CFM of air flow both units offer more CFM"}, "23"=>{"faqid"=>23, "faqtitle"=>"What is the battery life and how do I maximize it?", "faqdesc"=>"To get the most life out of your battery, you should remove it from the charger once it has finished charging. The problem with overcharging is the potential damage to the battery which can shorten its lifespan and leave you in a lurch if it quits in the middle of a project."}, "57"=>{"faqid"=>57, "faqtitle"=>"Can I leave my battery in the charger after charging it?", "faqdesc"=>"The battery chargers do have auto cut offs to prevent it from over charging. However, we do advise customers to remove the battery from the charger after it has been fully charged and to also unplug the charger from the outlet, as this is good electrical safety practice to do so. This will also help to prevent false defect readings and allows the charger to reset itself each time it’s used to charge a battery."}, "58"=>{"faqid"=>58, "faqtitle"=>"Why do batteries cost so much more than the tool?", "faqdesc"=>"The battery is the most important component for a battery-operated unit. Please be assured we price our batteries with the cost of material, manufacturing, and current market pricing in mind. \nBatteries are the costliest items to manufacture and ship in any kit. Full kits including a tool, battery, and charger are priced affordably so that consumers can begin building that line of tools and move forward purchasing tool-only units. When you purchase batteries on their own, it is more notable the cost that they carry."}, "59"=>{"faqid"=>59, "faqtitle"=>"How do I store the battery? Can I leave the battery in the garage or shed?", "faqdesc"=>"When the battery is not in use, we suggest storing it indoors, in a cool dry area - away from direct sunlight. Leave the charger unplugged and the battery disconnected from the charger unless it needs charging. It is recommended to store the battery with a full charge, and if it is being stored for a period where no use is expected, to check on the charge every couple of months. If you notice the charge has dropped, we advise charging the battery back up to full before returning it to its safe storage place. Following these steps will ensure you receive the most out of the battery life."}, "60"=>{"faqid"=>60, "faqtitle"=>"My battery is stuck in my tool. How do I get it out?", "faqdesc"=>"60V/ 80V Products: To remove the battery, push and hold the battery release button. Then, pull the battery pack straight out. In some cases, if the springs underneath have gotten locked down you might have to give a small push to the top of the battery to re-engage them to help the battery pop up. The battery pack fits snugly into the product to prevent accidental dislodging while in use; it may require a strong pull to remove. Before use, be sure that the rails on the battery and product are free of debris that could cause the battery to get stuck.\n\n24V/ 40V Products: To remove the battery, press the latch button on the battery pack down and hold. Pull the battery pack out of the handle. The battery pack fits snugly into the product to prevent accidental dislodging while in use; it may require a strong pull to remove. Before use, be sure that the rails on the battery and product are free of debris that could cause the battery to get stuck."}, "61"=>{"faqid"=>61, "faqtitle"=>"How do I check the charge on my battery?", "faqdesc"=>"Press the battery capacity indicator (BCI) button located at the end of the battery. The lights will illuminate according to the battery capacity level. Please note this switch does require a firm direct push using the tip of your finger. If the button is not being fully engaged, the lights will not activate. Please also be advised the lights only stay on for a few seconds and will automatically turn off. Another reason the lights will not power on is if the battery is completely depleted of power and needs to be charged."}, "62"=>{"faqid"=>62, "faqtitle"=>"Can I use any Greenworks battery in any Greenworks tool?", "faqdesc"=>"Our batteries are interchangeable with tools that are of the same voltage platform only. The difference between batteries of the same voltage is the ampere-hour (Ah) rating. The higher the ampere-hour (Ah) rating on the battery is the more run time it has to offer."}, "63"=>{"faqid"=>63, "faqtitle"=>"Are there certain tools that can’t accept all same voltage batteries?", "faqdesc"=>"There are a few exceptions. \n• Our 80V 20” snow thrower models 2600402 / 2605202 / 2601302 manufactured prior to September of 2017 can only use 2.0Ah or 2.5Ah battery models. \n• Our 60V 8.0Ah battery model 2957102 cannot be used in the following tools: any 60V 12\" Snow Shovel, any 60V 22\" Snow Blower, any 60V Tiller/Cultivator & any 60V Lawn Mower."}, "64"=>{"faqid"=>64, "faqtitle"=>"Do all batteries of the same voltage use the same charger?", "faqdesc"=>"Yes, they do. Each product line has designated charger models that can charge all batteries in that voltage platform, no matter the Ah rating."}, "134"=>{"faqid"=>134, "faqtitle"=>"Does battery temperature matter?", "faqdesc"=>"The temperature of the battery prior to use should not be too warm or too cold. For snow throwers if the battery is too cold it may not be operatable. Allow the battery to get to room temperature prior to use. For our other tools allow the battery to cool down prior to use if it’s too warm. To avoid battery temperature issues, batteries should be stored indoors in a dry and cool location. Information on battery storage and temperature will in inside your owner’s manual."}, "65"=>{"faqid"=>65, "faqtitle"=>"The charger indicates that my battery is fully charged but I was just using it and it depleted. Why isn’t it charging?", "faqdesc"=>"Putting a battery that was just in use onto the charger often results in a false full charge signal. Remove the battery from the charger and allow it to rest in a room temperature area for approximately 10-15 minutes before charging."}, "66"=>{"faqid"=>66, "faqtitle"=>"My charger is flashing red when I engage my battery. Why is this happening?", "faqdesc"=>"When the battery is inserted into the charger and the status LED blinks red, remove the battery from\nthe charger for 1 minute, then reinsert. If the status LED blinks green, then the battery is properly\ncharging. If the status LED is still blinking red, remove the battery and unplug the charger for 1 minute. After 1 minute, plug in the charger and reinsert the battery. If the status LED blinks green, then the battery is properly charging. If the status LED is still blinking red, then this likely indicates an issue with the battery or charger and should be taken care of either with our warranty team or by means of replacement."}, "67"=>{"faqid"=>67, "faqtitle"=>"My charger has a solid red light on it when I engage my battery. What is happening?", "faqdesc"=>"This typically indicates that the battery is at the wrong temperature to be charged. Allow the battery and charger to rest indoors at room temperature until they are no longer hot/cold and attempt charging again."}, "68"=>{"faqid"=>68, "faqtitle"=>"Are your chargers made for 220V or 120V outlets?", "faqdesc"=>"Greenworks chargers sold in the USA and Canada are designed for use on 120V outlets only."}}